The standard vertical injection molding machine is an important equipment for plastic processing and one of the main equipment for processing plastic products. Due to the technical level of the equipment or the operation of the injection molding personnel, various problems occur in the injection molding process of the injection molding machine. The deformation of the injection molding product is a common injection molding problem. For what reason? If the vertical injection molding machine has deformation of the injection molded product, it is necessary to find out the cause in time, reduce the scrapping efficiency of the product and save processing time.

The vertical deformation of the vertical injection molding machine can be found from the aspects of mold, plastic, processing, etc. The first is the mold of the vertical injection molding machine. It is necessary to pay attention to the design of the cooling system of the mold. Happening. Then there is the direction and shrinkage of the casting system stream. In terms of plastics, in the injection molding process of a vertical injection molding machine, the crystal form has more warpage deformation than that of the amorphous plastic injection molding. 

Therefore, the warpage deformation can be corrected by the crystallization process in which the plastic crystallinity decreases as the cooling rate increases and the shrinkage rate becomes smaller. There are so many deformations in the injection molding products of the established injection molding machine. It depends on which side is the reason for taking countermeasures.