1, The clamping strength is differentIf the force clamping part of the 20 160T injection molding machines is used on the die casting machine, the result is four broken head plates, three broken middle···
Recently, everyone is very concerned about the mask problem, and N95 is also out of stock. Before the different masks, which one is higher or lower?Are the masks for preventing smog and viruses the sa···
The core of injection molding machine maintenance work is the fault judgment and fault handling. It involves a wide range of knowledge, a large degree of complexity, and a certain depth (such as compr···
Vertical injection molding machine operation Pre-boot preparation Check that the parts are adequately lubricated. Check the oil pump for abnormal noise. Install ···
First: the formation of back pressure In the process of plastic melting and plasticizing, the molten material keeps moving to the front of the cylinder (the meterin···
operation 3.1 operation procedure of injection molding machine Mold closing → premolding → reverse shrinkage → nozzle advance → injection → pressure maintaining → nozzle receding → cooling → mold op···
The working principle of the injection molding machine is similar to the syringe used for injection, it is by means of screw (or plunger) thrust, has been plasticized good molten state (that is, visco···
The reason why the all-electric injection molding machine is welcomed by the market is that it has the performance that the full hydraulic injection molding machine can not achieve. Directly driving n···
